Discover the essential considerations for incorporating wholecrop and maize into your animal feed.
Wholecrop and maize can be a valuable addition to any ration, but attention to detail both pre- and post-harvest is key. Jamie Morton, of Krone, lists a few vital checks to make before heading into the field to harvest wholecrop.
He says: "Setting the header pressure correctly provides sufficient float without bouncing, thus avoiding soil ingress or knife damage and preventing premature bed wear.
Adjusting the drum bottom and blower correctly optimises crop flow and blow, resulting in better crop transition into trailers. Consider installing a grain saver plate to stop grain loss below feed-rolls.
For crops at the soft cheese growth stage, a crop processer will be needed on the harvester to enable starch digestion by the cow.
"Ensure the processor roller gap is aligned to the value shown on the harvester screen to avoid misinterpretation in the cab of the actual setting, resulting in uncracked grains.
Chop length will need to be adjusted according to the dry matter [DM] value of the wholecrop to ensure good consolidation in the clamp."
Peter Smith, of Volac, suggests wholecrop tends to be more difficult to consolidate as it is generally harvested at a higher DM than grass silage.
He says: "Deciding what type of feed is required will dictate when wholecrop is harvested.
Farmers looking for bulk will mow at 30-40% DM. "Most harvest it at 40-50% DM to balance digestibility with good starch levels.
At 50% DM, wholecrop is a high fibre feed and a processor will be necessary to crack the grain to allow the cow to digest it properly.
Additives such as Ecocool or Ecocorn help prevent heating in whole crop silage.
Fill the wholecrop evenly in the clamp with layers no thicker than 100-150mm to aid consolidation.
"Place a layer of fresh grass at least 0.5 metres deep on top of the wholecrop to deter vermin and add weight before covering carefully and weighting down."
Zinc and magnesium are the two most widespread nutrient deficiencies found in maize crops, according to Yara's Philip Cosgrave.
He says: "Maize is high yielding, but only if the nutritional demands of the crop are met. The critical stage for nutrition is when the crop reaches six leaves and rapid plant development begins."
Using foliar applications bypasses the root system and ensures fast and efficient absorption of nutrients and other bioactive compounds through the leaf.
Results from Yara's 2022 maize trial demonstrated the positive effect from combining foliar nutrition and a biostimulant on crop performance, increasing DM yield by an extra 2.5 tonnes/hectare.
"YaraVita BIOTRAC contains zinc, magnesium, potash and phosphate, stimulating root growth. The biostimulant in the product helps protect the crop against biotic factors, such as drought and cold temperatures.